Start with a clear block maker

Open the lid

Place a Plastic liners in the well

Place a Heavy Duty Clip at each end

Fill the well to about 2" from the top

This shows a full well

Place a Pump in opposing corners

Close the lid overnight

The next day remove 1 pump

Once the block is the desired thickness open

up the lid

Remove the 1 remaining Pump

Using a sump pump, suck out the water.  Some use vacuums, we like to have up to 3 pumps working simultaneously.  We also have a network of PVC, so a drain isn't more than 6' away

Clip in your lifter bar with Heavy duty lifter bar plates

We carry the block to the band saw with an overhead crane

Remove the lifter bar

Remove the Clip with a 6 prong pick or an Ice pick

Trim the blocks to the desired thickness